This guide applies to
The steps below cover the standard setup using the SHANWU Ceramic Universal Display Clip, support rod, and base.
Step 1
Place the flat side of the clip against the back of the ceramic fragment.
Step 2
Bend the two coated copper strips so they wrap around the fragment and hold it in place.
Step 3
Trim any excess copper strip with needle-nose pliers or a similar tool.
Optional step
For heavier fragments, or when 360° rotation is not needed, install the locking ring for added stability.
Step 4
Attach the support rod to the clip, then install the rod onto the base.
Step 5
Once installed, adjust the display angle as needed and the piece is ready for display.
Please note
- Handle ceramic fragments carefully during installation to reduce the risk of slipping or impact damage.